Difference between revisions of "WorkMan HVS - Cenium"
From WorkManSoft Wiki
Jump to navigationJump to search (Created page with "== About == WorkMan HVS works with Cenium from WorkMan HVS v 2.1 and using the Comtrol protocol. == Setup in WorkMan HVS == * The protocol being used is COMTROL. == Setup...") |
|||
| Line 11: | Line 11: | ||
* Make sure the Comtrol-communication is up and running. | * Make sure the Comtrol-communication is up and running. | ||
* Callcharge should be set to metered. | * Callcharge should be set to metered. | ||
| + | |||
| + | == Cleaning codes == | ||
| + | |||
| + | These are typically used (but can be different in your specific system!) | ||
| + | |||
| + | # Vacant dirty room | ||
| + | # Cleaning required | ||
| + | # Vacant clean room | ||
| + | # Occupied clean | ||
[[Category:WorkMan HVS]] | [[Category:WorkMan HVS]] | ||
Revision as of 09:36, 17 September 2013
About
WorkMan HVS works with Cenium from WorkMan HVS v 2.1 and using the Comtrol protocol.
Setup in WorkMan HVS
- The protocol being used is COMTROL.
Setup in Cenium
- Make sure the Comtrol-communication is up and running.
- Callcharge should be set to metered.
Cleaning codes
These are typically used (but can be different in your specific system!)
- Vacant dirty room
- Cleaning required
- Vacant clean room
- Occupied clean
