Difference between revisions of "WorkMan HVS - Cenium"
From WorkManSoft Wiki
Jump to navigationJump to search (Created page with "== About == WorkMan HVS works with Cenium from WorkMan HVS v 2.1 and using the Comtrol protocol. == Setup in WorkMan HVS == * The protocol being used is COMTROL. == Setup...") |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 11: | Line 11: | ||
* Make sure the Comtrol-communication is up and running. | * Make sure the Comtrol-communication is up and running. | ||
* Callcharge should be set to metered. | * Callcharge should be set to metered. | ||
| + | |||
| + | == Cleaning codes == | ||
| + | |||
| + | These are typically used (but can be different in your specific system!) | ||
| + | |||
| + | 1. Vacant dirty room | ||
| + | 2. Cleaning required | ||
| + | 3. Vacant clean room | ||
| + | 4. Occupied clean | ||
[[Category:WorkMan HVS]] | [[Category:WorkMan HVS]] | ||
Latest revision as of 10:32, 17 September 2013
About
WorkMan HVS works with Cenium from WorkMan HVS v 2.1 and using the Comtrol protocol.
Setup in WorkMan HVS
- The protocol being used is COMTROL.
Setup in Cenium
- Make sure the Comtrol-communication is up and running.
- Callcharge should be set to metered.
Cleaning codes
These are typically used (but can be different in your specific system!)
1. Vacant dirty room 2. Cleaning required 3. Vacant clean room 4. Occupied clean
