WorkMan HVS - Acceptance test

About

We recommend that the customer/implementer perform the following acceptance test to verify that their system is working. After our delivery we give a short time frame for these to be performed and after this period the test will be considered approved and any extra work will come at an additional fee. We reserve the right to add more tests as we discover more ways to test and adds features. All tests might not apply to your system.

AT#	OK	Function	Status/information/date for approval
1	NO	Call charge	Make call and verify log in HVS Config and PMS.
2	NO	Maid status	Dial and register appropriate maid statuses. Verify it exists in PMS.
3	NO	Wakeup 1	Create a wakeup by calling and registering a new wakeup call. Receive it a few minutes later.
4	NO	Wakeup 2	Create a wakeup but ignore answers, typically 4 attempts should be made to the room.
5	NO	Wakeup 3	Create a wakeup call, then call again and remove it.
6	NO	Wakeup 4	Create a wakeup call from reception, call again to verify it exists and then remove it.
7	NO	IP Office	Check in and out rooms, validate that they can't make public calls but can still register maidstatus/cleancode.
8	NO
9	NO
10	NO

Detailed information

AT#1

1. Go to a room that has been configured.
2. Make call to an external number e.g. your cellphone.
3. Verify that the call charge has been received in HVS Config/HVS Frontdesk.
4. Verify that the call charge has been sent to the PMS (Property Management System).

AT#7

This acceptancetest is specific to PBXes where we support opening and closening of extensions. Typically IP Office v 8 and later.

1. Checkin a room
2. Perform a call to a public number e.g. your cellphone
3. Checkout the room, wait a minute or so before trying the next step
4. Try to call a public number, it should be blocked
5. Call and register a maidstatus, it should work